gaqcu.blogg.se - How to change the memory space on stata 12

#How to change the memory space on stata 12 serial
#How to change the memory space on stata 12 software

The first 32 locations address the Register file, the next 64 location the standard I/O memory, then 160 locations of Extended I/O memory, and the next 4096 locations address the internal data SRAM. In normal mode, the first 4352 Data Memory locations address both the Register file, the I/O Memory, Extended I/O Memory, and the internal data SRAM. The Extended I/O space does not exist when the ATmega128 is in the ATmega103 compatibility mode. For the Extended I/O space from $60 - $FF in SRAM, only the ST/STS/STD and LD/LDS/LDD instructions can be used. The ATmega128 is a complex microcontroller with more peripheral units than can be supported within the 64 location reserved in the Opcode for the IN and OUT instructions. The ATmega128 supports two different configurations for the SRAM data memory as listed in Table 1.įigure 9 shows how the ATmega128 SRAM Memory is organized.

Current Consumption in Reset and Reset Pulse width.

#How to change the memory space on stata 12 serial

Two-wire Serial Interface Characteristics.Simple Assembly Code Example for a Boot Loader.

#How to change the memory space on stata 12 software

Reading the Fuse and Lock Bits from Software.

Setting the Boot Loader Lock Bits by SPM.

Changing Channel or Reference Selection.

16-bit Timer/Counter (Timer/Counter1 and Timer/Counter3).

8-bit Timer/Counter0 with PWM and Asynchronous Operation.

Timed Sequences for Changing the Configuration of the Watchdog Timer.

Using all 64KB Locations of External Memory.

Using all Locations of External Memory Smaller than 64 KB.